A closed cycle ocean thermal energy conversion basically involves a working fluid which has a boiling point just low below ambient temperature. This fluid is then evaporated using warm sea water and then used to run turbines. This evaporated gas is then condensed using cold seawater. In this paper a study is being made to install a super heater between the evaporator and the turbine. The various consequences due to this technical advancement have been discussed taking into consideration all the components in the OTEC plant. As the energy requirement to run pumps cannot be avoided, to increase the overall efficiency of the plant an effort is being made to increase the net energy output of the turbine. This can be achieved by heating the working fluid above its saturation temperature thus increasing its enthalpy indirectly increasing the net output of the turbine. Along with a super heater a pre-heater has been installed which helps to compensate the heat losses in heat exchangers. Both the super heater and pre-heater have been developed using non-conventional energy resources and no external energy input is required. Along with this an economic study has also been made which supports the proposed idea.
Published in | International Journal of Energy and Power Engineering (Volume 2, Issue 4) |
DOI | 10.11648/j.ijepe.20130204.11 |
Page(s) | 143-146 |
Creative Commons |
This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited. |
Copyright |
Copyright © The Author(s), 2013. Published by Science Publishing Group |
Gradient, Desalinized, Super heater, Pre heater
[1] | Luis A. Vega, Economics of Ocean Thermal Energy, American Society of Civil Engineers,1992 |
[2] | Dr. Hans Krock, Preliminary Analysis of Polymer Heat Exchangers |
[3] | Maria Bechtel and Erik Netz, OTEC |
[4] | H.P.Gupta, Solar Engineering |
[5] | Ruperi Mario, OTEC in Pacific Island |
APA Style
Aashay Tinaikar, Ajinkya Padate, Jainish Jain. (2013). Ocean Thermal Energy Conversion. International Journal of Energy and Power Engineering, 2(4), 143-146. https://doi.org/10.11648/j.ijepe.20130204.11
ACS Style
Aashay Tinaikar; Ajinkya Padate; Jainish Jain. Ocean Thermal Energy Conversion. Int. J. Energy Power Eng. 2013, 2(4), 143-146. doi: 10.11648/j.ijepe.20130204.11
AMA Style
Aashay Tinaikar, Ajinkya Padate, Jainish Jain. Ocean Thermal Energy Conversion. Int J Energy Power Eng. 2013;2(4):143-146. doi: 10.11648/j.ijepe.20130204.11
@article{10.11648/j.ijepe.20130204.11, author = {Aashay Tinaikar and Ajinkya Padate and Jainish Jain}, title = {Ocean Thermal Energy Conversion}, journal = {International Journal of Energy and Power Engineering}, volume = {2}, number = {4}, pages = {143-146}, doi = {10.11648/j.ijepe.20130204.11}, url = {https://doi.org/10.11648/j.ijepe.20130204.11}, eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.ijepe.20130204.11}, abstract = {A closed cycle ocean thermal energy conversion basically involves a working fluid which has a boiling point just low below ambient temperature. This fluid is then evaporated using warm sea water and then used to run turbines. This evaporated gas is then condensed using cold seawater. In this paper a study is being made to install a super heater between the evaporator and the turbine. The various consequences due to this technical advancement have been discussed taking into consideration all the components in the OTEC plant. As the energy requirement to run pumps cannot be avoided, to increase the overall efficiency of the plant an effort is being made to increase the net energy output of the turbine. This can be achieved by heating the working fluid above its saturation temperature thus increasing its enthalpy indirectly increasing the net output of the turbine. Along with a super heater a pre-heater has been installed which helps to compensate the heat losses in heat exchangers. Both the super heater and pre-heater have been developed using non-conventional energy resources and no external energy input is required. Along with this an economic study has also been made which supports the proposed idea.}, year = {2013} }
TY - JOUR T1 - Ocean Thermal Energy Conversion AU - Aashay Tinaikar AU - Ajinkya Padate AU - Jainish Jain Y1 - 2013/08/10 PY - 2013 N1 - https://doi.org/10.11648/j.ijepe.20130204.11 DO - 10.11648/j.ijepe.20130204.11 T2 - International Journal of Energy and Power Engineering JF - International Journal of Energy and Power Engineering JO - International Journal of Energy and Power Engineering SP - 143 EP - 146 PB - Science Publishing Group SN - 2326-960X UR - https://doi.org/10.11648/j.ijepe.20130204.11 AB - A closed cycle ocean thermal energy conversion basically involves a working fluid which has a boiling point just low below ambient temperature. This fluid is then evaporated using warm sea water and then used to run turbines. This evaporated gas is then condensed using cold seawater. In this paper a study is being made to install a super heater between the evaporator and the turbine. The various consequences due to this technical advancement have been discussed taking into consideration all the components in the OTEC plant. As the energy requirement to run pumps cannot be avoided, to increase the overall efficiency of the plant an effort is being made to increase the net energy output of the turbine. This can be achieved by heating the working fluid above its saturation temperature thus increasing its enthalpy indirectly increasing the net output of the turbine. Along with a super heater a pre-heater has been installed which helps to compensate the heat losses in heat exchangers. Both the super heater and pre-heater have been developed using non-conventional energy resources and no external energy input is required. Along with this an economic study has also been made which supports the proposed idea. VL - 2 IS - 4 ER -